Selling Subaru EA 82 (100hp) Hovercraft /Airboat engine ready to go. Engine: EA82 1992, 125,xxx when I pull it from a Subaru Loyal
 I went thru this engine.
*Replace both head gaskets
 While apart,I measured the cam's, compared to the Haynes manual numbers, no wear.*Replaced all seals
*Complete new set of lifters
*Changed out the distributor
*MSD Ignition with crank trigger pickup
 Rpm limiter, can be set at any RPM.
 (Crank trigger was installed after the video)
*Custom machined mount for new Weber Carburetor
*New water pump
*New timing belts (both)
*New alternator (Sabaru)
*Starter, with custom mount. This engine will comes with:*Engine stand that it is bolted to.
*New aluminum Radiator
*Aluminum Fuel tank, 11 gal round,(all fitting  already welded on, (only need to  
  bolt on your sending unit)
*New Fuel pump, with return lines.
*Machined flywheel.
*Custom machined drive line with just under 2:1 ratio pulleys.
*Pulleys and belt is 3-3/8" wide and are timing pulleys, (no slipping of belts)
*Flow master 2 into 2 muffler
 This engine is all together ready to run.
 
Ebay won't let me put a link here for  video
but you can do this if you need to see it running..

*The hub and 5 bladed prop is PowerFin and is 60" diameter
 
*Electronic angle finder to set blade angle that is ground adjustable.  Only thing that needs done is wire your battery to the alternator and starter and
  your off.
  Was going to put this engine in my project boat but I will be upgraded to a bigger engine. This is all mounted on two 2x4's with wheels, very easy to move around.
 I will help out with shipping as much as I can, or you can pick up at my place.
 I have used uship dot com, a few times, worked out great.
 Buyer pays shipping cost.
 I will crate for an additional $50 fee.
(All photo's are from the building process)hovercraft, airboat, flying, subaru, prop, airplane